PASS/EQUIP → Working with PASS/EQUIP → Data input → Main data input → Weld strength ratio

3.18.3. Weld strength ratio

This value is set based on weld type and materials used via button.

Fig. 1. Weld strength ratio as per GOST

Selection of this parameter depends on the accepted calculation code. Ff calculation is selected as per ASME VIII-1, weld strength factors are assigned concurrently (Fig. 2).

Fig. 2. Weld strength as per ASME

Fig. 3. Weld strength as per PNAE G-7-002-86